Howto use usbip on windows

To install the virtual usb bus driver on Windows XP:

1. Uncompress the downloaded binary package to a directory.

2. Double-click the ‘Add Hardware’ wizard in Control Panel.

3. At the ‘Welcome to the Add Hardware Wizard’, click ‘Next’.

4. Select ‘Yes, I have already connected the hardware’, then click Next.

5. Select ‘Add a new hardware device’ from the list, then click Next.

6. Select ‘Install the hardware that I manually select from a list(Advanced)’, and then click next.

7. Select ‘System Devices’, then click Next.

8. Click ‘Have Disk’, click ‘Browse’, choose the uncompressed directory, and click OK.

9. Click on the ‘Virtual USB Bus Enumerator’, and then click Next.

10. At ‘The wizard is ready to install your hardware’, click Next.

11. Click Finish at ‘Completing the Add/Remove Hardware Wizard.’

To use it:

1. open a command prompt window, cd to the uncompressed directory.

2. run usbip -l 192.168.2.1 to list the exported devices from ip 192.168.2.1

3. run usbip -a 192.168.2.1 2-1 to imported the device.

(Of course, you should change 192.168.2.1 and 2-1 to something else)

發表迴響

在下方填入你的資料或按右方圖示以社群網站登入:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / 變更 )

Twitter picture

You are commenting using your Twitter account. Log Out / 變更 )

Facebook照片

You are commenting using your Facebook account. Log Out / 變更 )

Google+ photo

You are commenting using your Google+ account. Log Out / 變更 )

連結到 %s